Installation Guide: Raspberry Pi 5 On-The-Go Hub – PWM Cooling & UPS Power

Installation Guide: Raspberry Pi 5 On-The-Go Hub – PWM Cooling & UPS Power

0. 3D Model Download

You can download the STL model from the following link. Feel free to modify it as needed to suit your requirements:

1. Securing Screws

Image:

  • 2 × M2.5*9+6 copper standoffs – to secure the Raspberry Pi
  • 4 × M2.5*7 hex-head screws – to secure the printed outer casing
  • 2 × M2.5*6 flat-head crosshead screws – to secure the UPS power board

Step 1: Attach the Raspberry Pi Board

Image:
Install 2 × M2.5*9+6 copper standoffs to secure the Raspberry Pi board to the metal heat-dissipation enclosure.

Step 2: Secure the UPS Power Board

Image:
Use 2 × M2.5*6 flat-head crosshead screws to attach the UPS power board to the 3D-printed battery compartment enclosure.

Step 3: Install the Orange Printed Button

Image:
Fit the orange printed button into the top-right corner of the battery compartment enclosure.

Step 4: Align and Combine the Enclosures

Image:
With the terminal connectors facing upwards on the same side, align and combine the left and right enclosures. Take care to match the UPS power pogo pins with the pins on the underside of the Raspberry Pi to avoid short-circuiting.

Step 5: Secure the Battery Compartment Enclosure

Image:
Finally, use 4 × M2.5*7 hex-head screws to fasten the battery compartment enclosure.

Back to blog